APPLIED GEOPHYSICS
 
        首页  |  版权声明  |  期刊介绍  |  编 委 会  |  收录情况  |  期刊订阅  |  下载中心  |  联系我们  |  English
应用地球物理  2012, Vol. 9 Issue (2): 159-167    DOI: 10.1007/s11770-012-0325-5
论文 最新目录 | 下期目录 | 过刊浏览 | 高级检索 Previous Articles  |  Next Articles  
消除滑动扫描地震数据中谐波干扰的反相关方法
张红静1,周辉1,Abd El-Aziz Khairy Abd El-Aal2,张洁1,3
1.油气资源与探测国家重点实验室, CNPC物探重点实验室, 中国石油大学(北京), 北京市昌平区 102249;
2. National Research Institute of Astronomy and Geophysics(NRIAG), Department of Seismology, Helwan, 11722 Cairo, Egypt;
3. 中国石化石油物探技术研究院, 南京市江宁区, 210014
The anti-correlation method for removing harmonic distortion in vibroseis slip-sweep data*
Zhang Hong-Jing1, Zhou Hui1, Abd El-Aziz Khairy Abd El-Aal2, and Zhang Jie1,3
1. State Key Laboratory of Petroleum Resource and Prospecting, CNPC Key Lab of Geophysical Exploration, China University of Petroleum, Changping 102249, China.
2. National Research Institute of Astronomy and Geophysics (NRIAG), Department of Seismology, Helwan 11722, Cairo, Egypt.
3. Sinopec Geophysical Research Institute, Jiangning 210014, Nanjing, China.
 全文: PDF (894 KB)   HTML ( KB)   输出: BibTeX | EndNote (RIS)      背景资料
摘要 滑动扫描技术是高效、高保真、环保的可控震源勘探技术之一,是可以使下一组震源不必等待上一组震源震动结束即可开始震动的高效采集方法。该技术由于缩短了相邻两炮的等待时间,使得生产效率得到显著提高。但是后一炮的谐波畸变与前一炮的基波信号混叠在一起,不易分离,在相关后的地震记录上形成了严重的谐波干扰,降低了地震资料的质量。本文提出一种反相关方法来压制滑动扫描地震数据中的谐波干扰。该方法首先把地面力信号分解为基波和各阶谐波分量;然后将后一炮的相关前数据分别与各分量相关,只选取正时间轴中对应分量的自相关部分,利用各分量的反相关算子提取各阶谐波信息;最后一炮数据中减去提取出的高阶谐波,得到压制谐波后的地震记录。该方法对有效信号影响小,可同时处理相关前和相关后数据,而且算法简单稳定,计算效率高。本文分别对理论模型和实际数据进行处理,验证了该方法消除谐波干扰的有效性。
服务
把本文推荐给朋友
加入我的书架
加入引用管理器
E-mail Alert
RSS
作者相关文章
张红静
周辉
Abd El-Aziz Khairy Abd El-Aal
张洁
关键词可控震源   滑动扫描技术   反相关算子   谐波干扰消除     
Abstract: The slip-sweep technique is one of the high-efficiency, high-fidelity, and environmental vibroseis seismic prospecting techniques which consists of a vibrator group sweeping without waiting for the previous group’s sweep to terminate. The cycle time can be reduced drastically and hence the production effi ciency can be increased signifi cantly but harmonic distortion of one sweep will leak into the record of the other sweep. In this paper,we propose an anti-correlation method for removing harmonic distortion in vibroseis data. This method is based on decomposition of the ground force signal into fundamental and harmonic components. Then the corresponding anti-correlation operator can be computed to estimate the energy of each harmonic after correlating the vibroseis data with the corresponding harmonic component. Finally, the vibroseis harmonic noise to be removed can be obtained by subtracting the extracted harmonic noise from the traces of the previous group’s sweep. The advantage of the proposed method is that it can process both uncorrelated and correlated vibroseis seismic data. Moreover, the algorithm is simple, stable, and computationally fast. Especially, the signifi cant contribution of this method is a considerable reduction in the harmonic without any alteration of the desired signals. The method was tested on both synthetic and field data sets to validate the good harmonic noise suppression results.
Key wordsvibroseis   slip-sweep acquisition   anti-correlation method   harmonic distortion removal   
收稿日期: 2011-10-12;
基金资助:

中国石油化工集团公司国际石油工程有限公司和中国石油天然气集团公司联合资助。

引用本文:   
张红静,周辉,Abd El-Aziz Khairy Abd El-Aal等. 消除滑动扫描地震数据中谐波干扰的反相关方法[J]. 应用地球物理, 2012, 9(2): 159-167.
ZHANG Hong-Jing,ZHOU Hui,Abd El-Aziz Khairy Abd El-Aal et al. The anti-correlation method for removing harmonic distortion in vibroseis slip-sweep data*[J]. APPLIED GEOPHYSICS, 2012, 9(2): 159-167.
 
没有本文参考文献
没有找到本文相关文献
版权所有 © 2011 应用地球物理
技术支持 北京玛格泰克科技发展有限公司